Epson ActionPC 5000 User Manual page 44

Follow these steps to install the IDE driver:
1. Insert the Drivers diskette 1 in drive A.
2. Log onto the IDE subdirectory on drive A.
3. Type
INSTALL
4. Follow the instructions on the screen to install the IDE driver
on your hard disk. This installation program changes your
system's CONFIG.SYS file so the system loads the IDE
driver as part of its startup procedure. If you select the IDE
driver for Windows, this program also modifies the
SYSTEM.INI file for Windows.
You should always install the IDE driver for DOS. If you are
using Windows, make sum you also install the IDE driver for
Windows. Windows must be installed before you install the
driver for Windows.
After you install the driver, the system reboots.
Note
Not all hard disk drives can take full advantage of the local
bus IDE interface. To take advantage of this feature, your
hard disk drive must support a 32-bit data path that utilizes
double-word I/O. To find out whether your hard drive
utilizes doubleword I/O, see the hardware specifications
for the drive or contact the drive manufacturer and request a
product specification.
Enter.
and press
Running SETUP and Installing Drivers 2-17