Installing A Hard Disk Drive Using The Mounting Bracket - Epson ActionPC 5000 User Manual

a
Installing
Bracket
You can install a hard disk drive below the diskette drive in the
mounting bracket, once you have removed the bracket and
drive from the computer. In order to fit in this space, your hard
disk drive must be 1 inch high by 3½ inches wide. If you have
a larger hard disk drive, you can install it in one of the drive
bays (see page 5-15).
This section includes steps for the following procedures:
(if necessary)
mounting bracket
If you have two hard disk drives, one must be configured as
the master (which contains your operating system), and the
other as the slave. Be sure to check the jumper settings on the
hard disk drive before you install it.
Also, you may need to know the number of cylinders, heads,
sectors, etc., if the hard disk drive auto-sensing feature in
SETUP is unable to correctly identify your drive. The hard disk
drive table used in the SETUP program is included in
Appendix A, along with a table of jumper settings for
high-capacity EPSON drives. If your drive is not listed or you
need more information, see the documentation that came with
your drive or contact the manufacturer.
5 - 4 Installing and Removing Drives
Hard Disk Drive Using the Mounting