Epson ActionPC 5000 User Manual page 36

If you set the Disk drive boot sequence option to
C: only, you should disable the Floppy seek option so the
system doesn't access the diskette drive during the startup
procedure. Disabling this option decreases the time needed to
start the system.
options on this screen determine what you see when
The other
your system starts.
The Display SETUP prompt during
allows you to disable the message
that you see during power-on diagnostics. You may
SETUP
want to disable this prompt to prevent unauthorized users
from seeing the
SETUP
disabled, however, you can still start SETUP by pressing F2
during power-on diagnostics.
The Pause on
POST errors
the error message, followed by the message
resume, <F2> to Setup that you see when the system
identifies a configuration error. If you disable this option, the
system ignores configuration errors it finds during power-on
diagnostics and starts as it normally would. It's a good idea to
keep this option enabled.
By disabling the System summary s c r e e n a t b o o t
option, you can disable the system summary screen that you
see when you start the system. If you disable this option, your
system starts more quickly. You can see the same screen by
selecting the System Summary option from the SETUP Main
Menu. (See page
2-14).
Press <F2>
prompt. Even when the message is
option allows you todisable
Running SETUP and Installing Drivers
POST Option
to enter
Press
<F1> to
2-9