Table of Contents
Advertisement
3. Restore data from a previously created Hardware Server Profile, press F10
NOTE:
When the restore process is complete, BIOS prompts to restore the system configuration data.
4. Restore data from a previously created Hardware Server Profile, press F10
5. To restore the system configuration data, press Y
6. To use the default configuration settings, press N
NOTE:
After the restore process is complete, system reboots.
NOTE:
If restoring the Service Tag is successful, you can check the Service Tag information in the System Information
screen and compare it with the Service Tag on the system.
Manually update the Service Tag
After replacing a system board, if Easy Restore fails, follow this process to manually enter the Service Tag, using System
Setup.
About this task
If you know the system service tag, use the System Setup menu to enter the service tag.
Steps
1. Power on the system.
2. To enter the System Setup, press F2.
3. Click Service Tag Settings.
4. Enter the service tag.
NOTE:
You can enter the service tag only when the Service Tag field is empty. Ensure that you enter the correct
service tag. Once the service tag is entered, it cannot be updated or changed. Incorrectly entered service tag will lead to
system board replacement.
5. Click OK.
LOM card and rear I/O board
Removing the LOM card and rear I/O board
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the system
board.
Steps
1. Using a Phillips # 2 screwdriver, remove the screws that secure the LAN on Motherboard (LOM) card and rear I/O board to
the system board.
2. Holding the edges, pull the LOM card or rear I/O board to disconnect from the connector on the system board.
Safety
instructions.
Before working inside your
system.
Installing and removing system components
231
Advertisement
Table of Contents
