Table of Contents
Advertisement
Table 9. Rear view of the system (continued)
Item
Ports, panels, or slots
9
VGA port
10
USB 3.0 port
11
Dedicated iDRAC9 Ethernet
port
12
System Identification (ID)
button
13
OCP NIC card
14
NIC ports
15
Power supply unit (PSU1)
Figure 10. Rear view of the system with 2 x 2.5-inch rear drive module
Table 10. Rear view of the system
Item
Ports, panels, or slots
1
PCIe expansion card riser 1
(slot 1 and slot 2)
2
BOSS blank
3
Rear Handle
4
PCIe expansion card riser 2
(slot 3 and slot 6)
Icon
Description
N/A
Enables you to connect a display device to the system. For more
information, see
The USB port is 9-pin and 3.0-compliant. This port enables you to
connect USB devices to the system.
Enables you to remotely access iDRAC. For more information,
see the Integrated Dell Remote Access Controller User's Guide at
www.dell.com/poweredgemanuals.
The System Identification (ID) button is available on the front and
back of the system. Press the button to identify a system in a rack
by turning on the system ID button. You can also use the system ID
button to reset iDRAC and to access BIOS using the step through
mode. When pressed, the system ID LED in the back panel blinks until
either the front or rear button is pressed again. Press the button to
toggle between on or off mode.
NOTE:
hold the System ID button for more than five seconds to enter
the BIOS progress mode
NOTE:
page by pressing F2 during system boot), press and hold the
System ID button for more than 15 seconds.
N/A
The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
The NIC ports are embedded on the LOM card that is connected to
the system board.
PSU1 is the primary PSU of the system. For more information
about the PSU configurations, see
section.
Icon
Description
N/A
The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the
installation guidelines
N/A
Insert BOSS blank when BOSS module is not used.
N/A
To lift the system.
N/A
The expansion card riser enables you to connect PCI Express
expansion cards. For more information , see the
installation guidelines
www.dell.com/poweredgemanuals
If the server stops responding during POST, press and
To reset the iDRAC (if not disabled on the iDRAC setup
www.dell.com/poweredgemanuals
section.
section.
section.
Expansion card
Expansion card
System overview
15
Advertisement
Table of Contents
