Initializing Tpm For Users; Initializing The Tpm 2.0 For Users - Dell PowerEdge R7625 Installation And Service Manual

Steps
1. Locate the TPM connector on the system board.
2. Press to hold the module down and remove the screw using the security Torx 8-bit shipped with the TPM module.
3. Slide the TPM module out from its connector.
4. Push the plastic rivet away from the TPM connector and rotate it 90° counterclockwise to release it from the system board.
5. Pull the plastic rivet out of its slot on the system board.
Installing the TPM
Steps
1. To install the TPM, align the edge connectors on the TPM with the slot on the TPM connector.
2. Insert the TPM into the TPM connector such that the plastic rivet aligns with the slot on the system board.
3. Press the plastic rivet until the rivet snaps into place.
4. Replace the screw that secures the TPM to the system board.
Figure 196. Installing the TPM

Initializing TPM for users

Steps
1. Initialize the TPM.
For more information, see
2. The TPM Status changes to Enabled, Activated.

Initializing the TPM 2.0 for users

Steps
1. While booting your system, press F2 to enter System Setup.
2. On the System Setup Main Menu screen, click System BIOS > System Security Settings.
Initializing the TPM for users.
Installing and removing system components 227