Installing The Internal Usb Card; Intrusion Switch Module; Removing The Intrusion Switch - Dell PowerEdge R7625 Installation And Service Manual

Installing the internal USB card

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the expansion card
Steps
1. Connect the USB key to the internal USB card.
NOTE: Ensure to install the internal USB card in the IDSDM/USB card slot and not in the J_R3_PCIE_PWR connector
slot.
2. Align the internal USB card with the connector on the system board and press firmly until the internal USB card is seated.
Figure 185. Installing the internal USB card
Next steps
1. Install the expansion card
2. Follow the procedure listed in
3. While booting, press F2 to enter System Setup and verify that the system detects the USB memory key.

Intrusion switch module

Removing the intrusion switch

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the air shroud.
4. Keep the plastic scribe ready.
216 Installing and removing system components
Safety instructions.
Before working inside your
risers.
risers.
After working inside your
Safety instructions.
Before working inside your
system.
system.
system.