Next steps
1.
Replace the BOSS card filler
Installing the BOSS card filler
Prerequisites
1. Follow the safety guidelines listed in the
Steps
Align the BOSS card filler with the BOSS-N1 controller card module bay and push it into the bay until it clicks into place.
Figure 175. Installing the BOSS card filler
Removing the BOSS-N1 controller card module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Pull and lift the BOSS-N1 card carrier retention latch lock to open.
2. Slide the BOSS-N1 card carrier out.
or
BOSS-N1 controller card
Safety
instructions.
Safety
instructions.
Before working inside your
module.
system.
Installing and removing system components
209