Table of Contents
Advertisement
Figure 200. Installing the LOM card and rear I/O board
Next steps
1.
Install the system
board.
2. Follow the procedure listed in
Control panel
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the drive backplane
4. If installed,
remove the air
5.
Remove the cooling fan
6.
Remove the side wall
Steps
1. Using the Phillips #1 screwdriver, remove the screws that secure the right control panel and the right control panels cable
cover to the system and remove the cable cover away the system.
2. Disconnect the right control panel cable and the VGA cable from the connectors on the system board.
3. Holding the cable, slide the right control panel out of the system.
NOTE:
Observe the routing of the cable as you remove the right control panel from the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
After working inside your
Safety
Before working inside your
cover.
shroud.
assembly.
bracket.
system.
instructions.
system.
Installing and removing system components
233
Advertisement
Table of Contents
