Adjusting The Platen Gap For Thick Or Thin Paper - Epson Stylus Pro 7880 User Manual

68 | Handling Paper and Other Media
Note: If you notice head
strikes on your prints,
make sure your paper is
flat. You can also try
changing the PLATEN
GAP setting to WIDE. If
that doesn't solve the
problem, try changing it
to WIDER.
Caution: To avoid
damaging the printer,
make sure you do not
select the NARROW
setting when you print
on thick media.

Adjusting the Platen Gap for Thick or Thin Paper

When you print on unusually thick or thin paper, you may need to adjust
the platen gap setting.
quality is not satisfactory when using very thin or very thick stock, you may
need to change this setting
1. Press the button.
Menu
2. Press the button again to select the Printer Setup menu and
Menu
highlight
PLATEN GAP
3. Press again.
Menu
4. Use the u or d button to choose
.
WIDEST
5. Press the button to save the setting. An asterisk appears next to the
selected setting.
6. Press the Pause button to exit the menu.
If you've selected a non-standard platen gap, the following symbols appear in
the corner of the display to remind you of the narrow or wide setting:
When you switch media, don't forget to change the setting back to
STANDARD.
If you're printing on non-Epson media and not using the Epson driver, you
may also need to create a paper configuration to optimize your results. See
page 74 for more information.
is the default setting. However, if print
STANDARD
.
.
is highlighted as the current setting.
STANDARD
NARROW
Widest
Wider
Wide
Narrow
68
, , , or
WIDE WIDER