Switching Between 2-Inch And 3-Inch Roll Paper; Cutting Paper Manually With The Built-In Cutter - Epson Stylus Pro 7880 User Manual

Note: A Manual Media
Cutting System is
available for heavy media.
See page 12 for details on
ordering it.

Switching Between 2-Inch and 3-Inch Roll Paper

You can convert the spindle to accept roll paper with a 3-inch core by using
the spindle adapters. Follow these steps:
1. Remove the black paper stop from the end of the spindle.
2. Slide one of the adapters onto the gray paper stop, then align the arrow
marks as shown below. Press the adapter until it locks in place. Press the
other adapter onto the black paper stop in the same way.
To remove the adapters, pull outward on the two tabs.
Pull outward on
tabs to release

Cutting Paper Manually with the Built-in Cutter

When you're not using the Auto Cut On setting, you may need to cut roll
paper manually by pressing a button after your print job is finished. You can
use the button to cut most types of paper.
However, if you're printing on fine art paper, canvas, or other heavy media,
you should use the optional Epson Manual Media Cutting System (see
page 190 for installation instructions) or scissors rather than the built-in
cutter. See page 56 for a list of media that should not be used with the
built-in cutter.
1. Before you print, press the l Paper Source button until you see the
roll (Auto Cut Off) icon on the LCD display.
2. Run your print job.
Handling Paper and Other Media
61
| 61