Unpacking And Assembling The Epson Stylus Pro 9880 - Epson Stylus Pro 7880 User Manual

WARNING: Two people are
required to unpack the
printer, and four are needed
to set it on the stand.
Note: When choosing a
place for the printer, leave
adequate room for easy
access and ventilation.
Avoid locations subject to
direct sunlight, excessive
heat, moisture, or dust.
Also avoid locations near
potential sources of
electromagnetic
interference, such as
loudspeakers, cordless
phones, TVs, or air
conditioners.
5. If you find that your roll paper is curled too tightly to eject properly,
attach the two paper guides to the bottom of the printer. See page 175
for more information.
6. Unlock the casters. Then move the printer to the place of use. (The
casters are meant for moving the printer for only a short distance.) Lock
the casters after moving.
7. Make sure you save the box and packaging in case you need to ship the
printer.
Now go to "Connecting the Power Cord" on page 39.
Unpacking and Assembling the
Epson Stylus Pro 9880
Follow these steps to assemble your printer and its stand. (If you have the
Epson Stylus Pro 7880, see page 19 instead.)
Before you begin, make sure you have sufficient space to set up and use the
printer. The following illustration shows the minimum space required for
using the Epson Stylus Pro 9880:
12 in.
(30 cm) 24 in.
(61 cm)
You will also need floor space of approximately 13 × 13 feet (4 × 4 m) to
assemble the printer and stand.
Setting Up the Printer
12 in.
(30 cm)
29
| 29
12 in.
(30 cm)