Warning: Make sure the
Auto Take-Up Reel is
installed properly and is
turned off before loading
paper. If it is installed
incorrectly or operates
unexpectedly, bodily
injury may occur.
Installing and Using Optional Equipment
Loading Roll Paper Onto the Take-Up Reel
Before you load roll paper onto the take-up reel core, check the following:
Turn off the Auto Take-Up Reel to avoid injury.
•
Make sure that the leading edge of the roll paper is straight.
•
Remove the center shaft from the upper basket hooks and the lower
•
shafts from the holes on the bottom of the base, then place the paper
basket under the printer.
Taking-Up Paper Forward
When you want paper wound onto the take-up reel with the print on the
outside, set the take-up reel to wind paper forward, as described below.
1. Attach the three paper guides that came with the Auto Take-Up Reel,
making sure to space them evenly.
2. Make sure that the roll paper is loaded in the printer properly. For
instructions, see page 55.
3. Press the l button to select
193
(Auto Cut Off).
|
193