Automatic Dc Calculation; Manual Thickness Upper Layer; Dc Value; Use Calculated Dc Value - Endress+Hauser Levelflex FMP55 Operating Instructions Manual

Levelflex FMP55 PROFIBUS PA

Manual thickness upper layer

Navigation
Description

DC value

Navigation
Description

Use calculated DC value

Navigation
Description
Endress+Hauser
"Automatic DC calculation" wizard
The Automatic DC calculation wizard is only available when operating via the local
display. When operating via an operating tool, all parameters concerning the
automatic DC calculation are located directly in the Interface submenu (→  115)
In the Automatic DC calculation wizard two parameters are displayed simultaneously
on the display module at any one time. The upper parameter can be edited, whereas
the lower parameter is displayed for reference purposes only.
Navigation 
 Setup → Advanced setup → Interface → Autom. DC calc. → Man.thick.up.lay
→  118
 Setup → Advanced setup → Interface → Autom. DC calc. → DC value
→  119
 Setup → Advanced setup → Interface → Autom. DC calc. → Use calc. DC
→  120
Setup → Advanced setup → Interface → Autom. DC calc.
Operating menu



121