Exchanging Media - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
A
Select an option.
To print at current settings:
Use the d/u buttons to select Keep Settings
Above and press the Z button.
Proceed to Step 6.
To change settings:
Use the d/u buttons to select Change Settings
and press the Z button.
B
Select the items you want to change and press the
Z button.
C
Select the desired option and press the Z
button.
D
Press the y button to display the dialog shown in
Step 2 and then press the y button again.
E
After confirming that the settings are correct, use
the d/u buttons to select Keep Settings Above
and press the Z button.
F
If On is selected for Remaining Setup, you will
be prompted to enter the length of the current
media.
Use the d/u buttons to choose a length between
5.0 and 99.5 m (15 and 300 ft) and press the Z
button. You can set in 0.5m increments. If the
display is in feet, lengths are given in increments
of 1 ft.
The printer will display Ready after a brief pause,
showing that it is ready to print. Transmit the data to be
printed from the computer.

Exchanging Media

To replace the media after printing, print the amount of
media remaining, cut the media, and remove the roll.
Printing the Amount of Media
Remaining
The printer displays the amount of media remaining
and any media low warnings in the control panel. This
makes it possible to determine whether the media
requires replacement before printing.
Basic Operations
The amount of media remaining can only be displayed if
the correct length is entered when the media is loaded.
You can print the amount of media remaining on the
leading edge of the roll before it is removed from the
printer and then enter this number the next time the
media is loaded for accurate information on the amount
remaining.
Note:
The printer does not calculate or display the amount of
media remaining when Off is selected for Remaining
Setup in the setup menu.
"Viewing and Changing Media Settings" on
U
page 32
The following section describes how to print the
amount of media remaining.
Buttons that are used in the following settings
A
Confirm that the printer is ready to print.
B
Press the M button, select Media Remaining in
the menu, and press the Z button.
C
Select Print Remaining Length and press the
Z button.
D
Press the Z button to print the amount of
media remaining.
33