Basic Operations; Loading And Exchanging Media; Loading Media - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide

Basic Operations

Loading and Exchanging
Media

Loading Media

The procedure for loading media varies depending on
whether you are using the installed media feeding unit
or the optional heavy roll media system.
Follow the steps below when using the supplied media
feeding unit.
When the Heavy Roll Media Feeding Unit is installed,
see: U "Using the Optional Heavy Roll Media Feeding
Unit" on page 27
When the Standard Media Feeding
Unit Is Installed
This section describes how to load media when the
standard media feeding unit is installed.
!
Caution:
❏ Because the media is heavy, it should not be
carried by one person. When loading or
removing the media, use at least two persons.
❏ The heaters and media holding plates may be
hot; observe all necessary precautions. Failure
to observe the necessary precautions could
result in burns.
❏ Be careful not to trap your hands or fingers
when opening or closing the front cover.
Failure to observe this precaution could result
in injury.
c
Important:
Load media immediately before printing. The
pressure rollers may crease media left in the printer.
The media may also become wavy or curled,
causing jams or resulting in the media coming into
contact with the print head.
Basic Operations
Note:
For information on the media that can be used in the
printer, see:
"Supported Media" on page 94
U
A
Turn on the printer by pressing the P button.
B
Loosen the roll holder fixing screws and adjust
the roll holders so that the gap between the two is
wider than the media.
Center the roll supports between the roll holders.
c
Important:
If the right holder handle shaft is not visible,
rotate the holder forward until it stops. The
media can not be properly loaded if the handle
shaft is not visible.
C
Place media on the roll support oriented
according to how it is rolled (see below) and
position it as indicated by the mark on the label.
Printable side out
22