Epson SureColor SC-S30600 User Manual page 31

SC-S30600 Series User's Guide
N
Pull the media straight forward until the edge has
past the label on the left side of the after heater.
Keep the right edge of the media parallel with the
scale markings on the two labels on the right side
of the after heater.
O
Lower the media loading lever to hold the media
in place.
To print immediately, proceed to Step 16.
For information on loading the media into the
auto take-up reel unit, see:
"Using the Auto Take-up Reel Unit" on
U
page 35
Basic Operations
Note:
If you would prefer to print from the very start of the
roll, press the u button in the control panel to
rewind the media slightly.
Be sure, however, to stop rewinding before the
leading edge of the media is over the cutter groove
(on the pressure roller side).
P
Attach the media holding plates at either side of
the media.
First, position the plates so that the edges of the
media are in the centers of the round holes. Next,
adjust the position until the white line is visible in
the square window and push the plates down to
lock them in place.
31