Epson SureColor SC-S30600 User Manual page 8

SC-S30600 Series User's Guide
F
Roll support
Rest media temporarily on these supports when removing the take-up roll. There are two supports: one on the left
and one on the right.
G
Auto switch
Use this switch to select the auto take-up direction. Choose Off to disable auto take-up.
H
Manual switch
Use this switch to select the manual take-up direction. The selected option takes effect when the Auto switch is in
the Off position.
I
Casters
There are two casters on each leg. Once installation is complete, the front casters should be kept locked while the
printer is in use.
J
Airflow vents
These vents vent air from inside the printer. Do not obstruct these vents.
K
Waste ink bottle holder
Place the waste ink bottle in this holder.
L
Adjuster
The adjusters keep the printer in place. After installing the printer, keep it securely in place during use.
M
Waste ink bottle
Waste ink collects in this bottle.
Replace with a new waste ink bottle when the level approaches the line.
N
Waste ink tube
Waste ink is discharged from this tube. Be sure the end of this tube is in the waste ink bottle while the printer is in
use.
O
Ink cartridges
Install all ink cartridges into each slot.
P
Lock levers
Raise the levers to unlock the ink cartridges prior to removal. Lower the levers to lock the cartridges in place after
insertion.
Q
Cartridge check lamp
This lamp lights when an ink cartridge error occurs.
On : An error occurred. Check the contents of the error on the control panel's screen.
Off : No error.
R
AC inlet #1/AC inlet #2
Connects the power cable. Be sure to connect both cables.
S
LAN port
Connects the LAN cable.
T
USB port
Connects the USB cable.
Introduction
8