Supported Media; Moving And Transporting The Printer; Moving The Printer - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide

Supported Media

The following media can be used with the printer.
Print quality is greatly affected by the type and quality of
media used. Choose a media suited to the task at hand.
For information on use, refer to the documentation
supplied with the media or contact the manufacturer.
We recommend that you print a test run and check the
results before purchasing media in large quantities.
c
Important:
Do not use media that is wrinkled, scuffed, torn, or
dirty.
Standard Roll Media System
Roll core size 2 or 3 inch
Roll outer diameter Up to 250 mm
Media width 300 to 1626 mm (64 inch)
Media thickness Up to 1 mm
Roll weight Up to 40 kg
Heavy Roll Media System
Roll core size 2 or 3 inch
Roll outer diameter Up to 300 mm
Media width 300 to 1626 mm (64 inch)
Media thickness Up to 1 mm
Roll weight Up to 80 kg
Appendix
Moving and Transporting
the Printer
This section describes how to move and transport the
product.

Moving the Printer

This section assumes that the product is being moved to
another location on the same floor without traversing
stairs, ramps, or lifts. See below for information on
moving the printer between floors or to another
building.
"Transport" on page 95
U
!
Caution:
Do not tilt the product more than 10 degrees
forward or back while moving it. Failure to observe
this precaution could result in the printer falling
over, causing accidents.
c
Important:
Do not remove the ink cartridges. Failure to observe
this precaution could cause the print head nozzles to
dry out.
Getting Ready
A
Confirm that the printer is off.
B
Remove the waste ink bottle.
"Replacing the Waste Ink Bottle" on
U
page 59
C
Disconnect the power cords and all other cables.
D
Remove media from the media feeding unit and
auto take-up reel unit.
94