Epson SureColor SC-S30600 User Manual page 79

SC-S30600 Series User's Guide
Item
Print Start Position
Media Size Check
Media End Check
Media Skew Check
Auto Nozzle Check
Nozzle Check Cycle
Options When
Clogged
Using the Control Panel Menu
Parameter Explanation
0 to 800 mm (0.00 Adjust this parameter if you want to print from the near center of the
to 32.00 inch) media or if you want to shift the printed area left from the Side
Margin(Right) setting. The area between the right edge of the media and
Print Start Position is left blank. If a value is selected for Side
Margin(Right), an additional area corresponding to the width selected
for Side Margin(Right) will be left blank. The position from which the this
parameter is measured varies with the option selected for Media Size
Check.
On selected for Media Size Check: The right edge of the media.
Off selected for Media Size Check: The default right edge reference
position (as far as the platen past the center of the label on the pre-heater).
"Printable area" on page 49
U
On Choose whether the printer automatically detects (On), or does not
automatically detect (Off), the edges of the media. Try Off if the printer
Off
displays a Media Size Error when the media is correctly loaded. Note,
however, that the printer may print beyond the edges of the media when
Off is selected. Ink used outside the edges of the media will stain the inside
of the printer. We generally recommend to operate with this setting set to
On.
On
Choose whether the printer automatically detects (On) or does not
automatically detect (Off), the end of the media. Try Off if the printer
Off
displays Media Out when the media is correctly loaded. We generally
recommend to operate with this setting set to On.
On When skewed media is detected, the printer will either stop printing and
display an error (On) or continue printing (Off). On is recommended in
Off
most circumstances, as skewed media may cause the printer to jam.
Off Choose the frequency with which the printer performs an Auto Nozzle
Check: never (Off) or once every 1 to 10 pages. Auto nozzle checks will not
1 to 10 pages
be performed while Off is selected. If 1 to 10 is selected, the printer will
automatically checks for clogs at the specified interval by scanning a test
pattern with a sensor as it is being printed.
Note that Auto Nozzle Check is not capable of detected all types of clog.
In addition, Auto Nozzle Check is not available under the following
conditions:
❏
The media is transparent or colored.
❏
The printer is exposed to direct sunlight or interference from other
ambient light sources.
Shade the printer from sources of interference.
❏
2.5 is selected for Platen Gap in the setup menu.
Choose another option for Platen Gap.
Continue Printing Choose how the printer responds when an auto nozzle check detects
clogged nozzles.
Stop Printing
If Continue Printing is selected, the printer will display Nozzle Clog
Detected but keep printing. Perform head cleaning if you judge it
necessary on inspecting the print results.
If Stop Printing is selected, the printer will display Nozzle Clog Detected
and pause printing. Inspect the print results and choose whether to
resume or suspend printing according to the extent of the clog.
79