Viewing And Changing Media Settings - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
c
Important:
❏ Do not use the media holding plates with
media that is more than 0.4 mm thick.
The media holding plates could touch
and damage the print head.
❏ Move the media holding plates to the left
and right edges of the platen when they
are not in use.
❏ Do not use the media holding plates if the
sides of the printed media are smudged or
torn.
❏ Leave left and right margins of over 10
mm when using the media holding
plates. Narrower margins could result in
printer printing over the plates.
Q
Close the front cover.
Viewing and Changing Media
Settings
The control panel displays the following information
once the media is loaded.
This display can be used to view or change the following
two options:
Basic Operations
❏ Remaining Setup
On: The printer displays the amount of media
remaining.
Off: The printer does not display the amount of
media remaining.
When Remaining Setup is On, the printer will
calculate the approximate amount of media
remaining based on the length of the roll and the
amount used for printing and display this
information in the control panel. The display gives
a rough idea of the amount of media available
before printing, making it easier to know when
media requires replacement.
In addition, a warning will be displayed when the
amount of media remaining reaches a specified
level.
❏ Selected Media
Displays the parameters on which media settings
are based as shown below.
RIP Settings: Media settings are based on those
in the RIP.
XXXXXXXXXXXXXXXXXX: Media settings
are based on those stored in the printer in media
settings bank No. 1.
Media settings banks can store a variety of settings
for different media based on the options selected in
the Heater Temperature, Media Suction, Head
Alignment, and other menus. Up to 30
combinations of settings can be stored by assigning
them to banks No. 1 to 30.
Media Settings U
Buttons that are used in the following settings
32
"Saving Settings" on page 41