Epson SureColor SC-S30600 User Manual page 77

SC-S30600 Series User's Guide
Item
Heater Temperature
Drying Time Per Pass
After Heater Feed
Additional Dryer
Media Suction
Head Movement
Multi-Strike Printing
Roll Type
Using the Control Panel Menu
Parameter Explanation
Pre-heater/platen The temperatures for the pre-, platen, and after heaters can each be
heater: 30 ˚C to adjusted separately.
50 ˚C (86 ˚F to
122 ˚F)
After heater: 30 ˚C
to 55 ˚C (86 ˚F to
131 ˚F)
0 to 10sec Select the time the print head pauses to allow drying after each pass.
Choose from values between 0.0 and 10.0 seconds. The time needed for
the ink to dry varies with ink density and the media used. If the ink blurs on
the media, set a longer time for drying the ink.
Increasing the drying time increases the time needed to print.
Mode 1 To feed media to the after heater after printing, choose Mode 1 or Mode 2;
otherwise, choose Off.
Mode 2
If Mode 1 is selected, the portion fed for drying will not be rewound before
the next job starts. Select this option if the media will be cut before the next
Off
job starts.
If Mode 2 is selected, the portion fed for drying will be rewound before the
next job starts, eliminating unnecessary margin. Select this option if
multiple jobs will be printed consecutively.
On Select On to enable, or Off to disable, the optional additional print drying
system. Note that even when On is selected, the additional print drying
Off
system will turn off with the heaters when the Heat Off Timer expires. The
additional print drying system will turn back on when the heaters resume
operation. Heat Off Timer U
This item is displayed only when the optional additional print drying
system is installed.
0 to 10 Suction is required to maintain the correct distance between the media
and the print head; the amount needed varies with the type of media.
Excessive suction can increase the gap between the print head and thin or
flexible media, potentially reducing print quality or preventing the media
feeding normally. In such cases, you will need to lower media suction. The
suction power is weakened when the parameter is lowered.
Data Width Choose the range in which the print head moves during printing.
Data Width restricts print head movement to the printed area. Restricting
Printer Full Width
the extent of print head movement increases print speed.
If Printer Full Width is selected, the print head will move the full width of
the largest media supported by the printer. Select this option for more
even print results with less variation.
Off Choose the number of times each line is printed.
2 to 8
Printable Side Out Choose Printable Side Out or Printable Side In according to how the
media is rolled.
Printable Side In
"Printer Setup Menu" on page 78
77