Notes On Usage And Storage; Installation Space; Notes When Using The Printer - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
Notes on Usage and
Storage

Installation space

Make sure that you secure the following space, clear of
any other objects, so that paper ejection and
consumable replacement are not obstructed.
See the "Specifications Table" for the external
dimensions of the printer.
"Specifications Table" on page 96
U

Notes when using the printer

Note the following points when using this printer to
avoid breakdowns, malfunctions, and print quality
decline.
❏ When using the printer, observe the operating
temperature and humidity range described in the
"Specifications Table". U
on page 96
Note, however, that the desired results may not be
achieved if the temperature and humidity are
within the limits for the printer but not within those
for the media. Be sure the operating conditions suit
the media. For more information, see the
documentation supplied with the media.
Also, when operating in dry areas, air conditioned
environment, or under direct sunlight, maintain
the appropriate humidity.
❏ Avoid using the printer in locations with heat
sources or that are exposed to direct draughts from
ventilators or air conditioners. The print head
nozzles could dry out and clog.
Introduction
"Specifications Table"
16
❏ Do not bend or tug the waste ink tube. Ink could
spill inside or around the printer.
❏ The following components require regular
maintenance at recommended intervals or
according to the frequency with which the printer is
used. Failure to perform regular maintenance could
result in loss of print quality. In the absence of the
appropriate maintenance, continued use could
damage the print head.
"Regular Maintenance" on page 53
U
Component to be
cleaned
Print head
Wiper
Caps
Component requiring
replacement
Flushing pad
Wiper cleaner
Wiper
❏ The print head may not be capped (the print head
may not return to the right side) if the printer is
turned off when the media is jammed or an error
has occurred. Capping is a function for
automatically covering the print head with a cap
(lid) to prevent the print head from drying out. In
this case, turn on the power and wait a while until
capping is performed automatically.
❏ When the power is on, do not remove the power
plug or cut the power at the breaker. The print head
may not be capped properly. In this case, turn on the
power and wait a while until capping is performed
automatically.
❏ The print head is automatically cleaned at a fixed
interval after printing to keep the nozzle from
clogging.
Be sure that the waste ink bottle is placed whenever
the printer is on.
Frequency
❏
Once a week
❏
When colors in the
printout are faint or
missing even after
head has been
cleaned.
Frequency
Once every six months