Before Printing - Epson SureColor SC-S30600 User Manual

SC-S30600 Series User's Guide
G
Lower the roll onto the roll support.
Using the Optional Heavy Roll Auto
Take-up Reel Unit
This section explains how to remove media from the
take-up reel using a lifter.
The following types of lifter can be used.
❏ Fork or platform thickness: 28 mm or less
❏ Fork or platform can be lowered to approx.190mm
from the floor.
!
Caution:
Because the media is heavy, it should not be carried
by one person. When loading or removing the
media, use at least two persons.
Using a lifter is recommended when handling a
media that is 40 kg or heavier.
A
Cut the media and roll the cut end onto the
take-up reel.
"Cutting Media" on page 34
U
B
Insert the lifter between the media and the auto
take-up reel unit and adjust the height to support
the take-up roll.
Basic Operations
C
Loosen the left roll core holder fixing screw and
remove the roll core holder from the roll.
D
Loosen the right roll core holder fixing screw and
remove the roll core holder from the roll.

Before Printing

To maintain print quality, perform the following
inspection before starting work each day.
❏ Check the amount of ink remaining:
If ink is expended during printing, printing can be
resumed once the affected cartridge has been
replaced. Note, however, that depending on how
much the ink has dried, replacing ink during
printing may cause apparent changes in hue. If you
know that the print job will be a large one, we
recommend that you use new cartridges to replace
those that are running low before you start. The old
cartridges can be reinserted and used at a later date.
Ink level is shown by an icon. U
the Display" on page 13
Replacing Ink Cartridges U
page 67
40
"Understanding
"How to replace" on