Table of Contents
Advertisement
SC-T3100x Series
User's Guide
Notes on Usage and
Storage
Installation space
Make sure that you secure the following space, clear of
any other objects, so that paper ejection and
consumable replacement are not obstructed.
See the "Specifications Table" for the external
dimensions of the printer.
"Specifications Table" on page 166
U
With stand (optional)
W
D
1020 mm
1000 mm
Without stand (optional)
W
D
1020 mm
1035 mm
Introduction
* You need at least 150 mm of space at the back when
replacing the maintenance box.
Notes when using the printer
Note the following points when using this printer to
avoid breakdowns, malfunctions, and print quality
decline.
❏ When using the printer, observe the operating
❏ Do not install the printer next to heat sources or
❏ The print head may not be capped (i.e., may not
H
1078 mm
❏ When the power is on, do not remove the power
❏ As well as when printing, the printer also uses ink
❏ The printer may automatically perform print
H
395 mm
17
temperature and humidity range described in the
"Specifications Table".
"Specifications Table" on page 166
U
Even when the conditions above are met, you may
not be able to print properly if the environmental
conditions are not suitable for the paper. Be sure
to use the printer in an environment where the
paper's requirements are met. For more details,
see the documentation supplied with the paper.
Also, when operating in dry areas, air conditioned
environment, or under direct sunlight, maintain
the appropriate humidity.
directly in the path of air from a ventilator or air
conditioner. Failure to observe this precaution
could result in the print head nozzles drying and
clogging.
move to the right-hand side) if an error occurs
and the printer is turned off without first
resolving the error. Capping is a function for
automatically covering the print head with a cap
(lid) to prevent the print head from drying out. In
this case, turn on the power and wait a while until
capping is performed automatically.
plug or cut the power at the breaker. The print
head may not be capped properly. In this case,
turn on the power and wait a while until capping
is performed automatically.
from all cartridges during print head cleaning and
other maintenance operations to keep the print
head in good condition.
head cleaning to maintain good printing quality.
Please wait until cleaning finishes without
opening any of the covers or turning off the power.
Advertisement
Table of Contents
