Epson Stylus Pro 7900/7910/9900/9910
J
Set the number for #1 LC to #4 VLM, and then
press the
button.
If you are not satisfied with the result of this
alignment, see the next section to try BI-D ALL.
After you set the patterns, press the
button to return to the READY state.
Bi-D ALL alignment
A
Press the
/
and then press the
pattern.
Note:
When you print the pattern on a cut sheet media,
you need to prepare several sheets. When the first
page is printed, set the next paper.
B
Check the pattern and select the set number that
has the smallest gaps.
C
When BI-D ALL #1 C appears on the LCD
panel, press the
number, and then press the
D
Set the number for #1 C to #4 VLM, and then
press the
button.
User's Guide
button to select BI-D ALL,
button to print a
/
button to select the
button.
Cleaning the Printer
To keep your printer in top operating condition, clean
it thoroughly if it becomes soiled.
Caution:
c
Take care to prevent water or other foreign
matter getting inside the printer. If moisture, dirt,
or other matter gets inside of the printer, besides
affecting print quality, it may cause the electric
circuits to short.
Cleaning outside of the printer
A
Remove the paper from the printer.
B
Make sure the printer is turned off and all the
lights are off, and then unplug the power cord
from the electrical outlet.
C
Use a soft, clean cloth to carefully remove any
dust or dirt.
If the dirt does not come off, clean it using a soft,
clean cloth dampened with a mild detergent.
Then, wipe the outside of the printer with a dry,
soft cloth.
Caution:
c
Never use alcohol or thinners to clean the
printer; these chemicals can damage the
components as well as the case.
Maintenance
85