Epson Stylus Pro 7900 User Manual page 49

Epson Stylus Pro 7900/7910/9900/9910
G
Tape the leading edge of the roll paper to the
take-up reel core in three places.
H
Press the button to feed the paper forward
and create a loop of slack.
I
Set the Manual switch to Forward and hold it
for a while to take up the roll paper for three or
more revolutions of the take-up paper core.
After taking up the paper, ensure that there is
adequate slack between the roll paper and the
take-up reel core.
Note:
For Singleweight Matte Paper with a 24-inch
width or wider, place the Tensioner in the slack
of the roll paper. Make sure to place it in the
center of the roll paper.
User's Guide
Winding paper backward
A
Turn on the printer, and then pull out the roll
paper. See step 3 to 6 of the following section.
"Winding paper forward" on page 48
B
Pull the bottom of the roll paper around the
back of the reel core as shown below. Then tape
the leading edge of the paper to the reel core in
three places.
C
Press the
and create a loop of slack.
D
Set the Manual switch to Backward and hold it
for a while to take up the roll paper for three or
more revolutions of the take-up paper core.
After taking up the paper, ensure that there is
adequate slack between the roll paper and the
take-up reel core.
button to feed the paper forward
Paper Handling 49