When Using This Product - Epson Stylus Pro 7900 User Manual

Epson Stylus Pro 7900/7910/9900/9910
O If you use an extension cord with this product,
make sure the total ampere rating of the devices
plugged into the extension cord does not exceed
the cord's ampere rating. Also, make sure the total
ampere rating of all devices plugged into the wall
outlet does not exceed the wall outlet's ampere
rating.
O Do not attempt to service this product yourself.
O Unplug this product and refer servicing to
qualified service personnel under the following
conditions:
The power cord or plug is damaged; liquid has
entered the product; the product has been dropped
or the cabinet damaged; the product does not
operate normally or exhibits a distinct change in
performance.
O If you plan to use the printer in Germany, observe
the following:
To provide adequate short-circuit protection and
over-current protection for this printer, the
building installation must be protected by a 10 or
16 amp circuit breaker.
O If damage occurs to the plug, replace the cord set
or consult a qualified electrician. If there are fuses
in the plug, make sure you replace them with fuses
of the correct size and rating.
User's Guide

When using this product

O Do not put your hand inside this product or touch
the ink cartridges during printing.
O Do not move the print heads by hand; otherwise
you may damage this product.
O Always turn the product off using the Power
button on the control panel. When this button is
pressed, the Power light flashes briefly then goes
off. Do not unplug the power cord or turn off the
product until the Power light stops flashing.
Safety Instructions 7