Switching The Cmm On; Safety Measures And Notes; Cmm Starting Sequence - Zeiss CONTURA Operating Instructions Manual

Switching the CMM on

Switching the CMM on

6-12

Safety measures and notes

Visual inspection
NOTE
A visual check must be carried out before turning on the CMM. The
CMM may be switched on only if it is in proper working order.
— Make sure that the CMM is in proper working order.
AUTO operating mode
NOTE
When starting an automatic measuring run, nobody may stay in the
danger zone of the CMM.
— Check to ensure that no one is in the danger zone of the CMM.
NOTE
Maximum speed may only be used if the automatic measuring run has
been tested at low speed beforehand. This is to prevent collisions at
high travel speeds.
NOTE
The maximum speed may be reduced by several marginal conditions.
Examples of reduced maximum speed:
– The control knob for the speed setting on the control console is
turned back.
– The default speed in the measuring software is reduced.
Measuring software
NOTE
The probe must be connected to the ram before starting the measuring
software.

CMM starting sequence

When starting the CMM, proceed in the following order:
1. Turn on the controller.
2. Turn on the drives.
61211-1310402 CONTURA