Communication Setup - GE MAC 1600 Operator's Manual

Communication Setup

2028451-182B
NOTE
For treadmills and ergometers, you reset to factory defaults at
the protocol level. Refer to step 15.
12. Repeat step 8 through step 10 as necessary.
13. To rename the protocol, do the following:
a. Press F4 (Edit Name).
The Edit Name window opens.
NOTE
This option is not available when editing a Master Step
protocol.
b. Change the name as appropriate.
c. Press F6 (OK).
The protocol's name is changed.
14. When you are done with the stages, press F6 (Save).
This saves your changes and returns you to the previous window.
15. To remove custom protocols, press F5 (Factory Defaults).
16. When the protocol is done, press F6 (Return).
The protocol is saved and you return to the Select Protocol window.
The Communication Setup function allows you to define:
Basic communication settings
Shared directory settings
Destination location settings
Modem settings (if a modem option is activated)
LAN settings (if a LAN option is activated)
To reach the Communication Setup from the MAC 1600 Main Menu,
press F5 (System Configuration) > F6 (More) > F1 (Communication
Setup).
The following table describes the settings on Communication Setup.
Field
Page 1
Default Location
MAC™ 1600
Comment
Determines which of the four available communication
locations will be the default. The locations are defined on
page 2 of Communication Setup.
System Configuration
9-19