Table of Contents
Advertisement
8.1.7
W905 Cable Connection
<Dimensions of RS232C cable connector set hole>
When mounting the W5 cable D–SUB connector on the cabinet, observe the following
steps.
1)
Remove the connector screws and square nuts.
2)
Pass the W5 cable through the hole from the outside of the cabinet.
3)
Secure the connector with the screws from the inside of the cabinet. Secure the
connector cap in the square nut groove on the Pin 1 side.
24.99
21
4–R1.6
2–ø3.2
10°
Outside of cabinet
Inside of cabinet
– 122 –
STE 73843
Advertisement
Table of Contents
