Axis I/O Port Dc Outputs - Danaher Motion Standalone MMC Hardware Manual

Danaher Motion
Description
Axis Connector Breakout Box
MMC Axis A"n" to Breakout Box Cable
MMC Axis A"n" to Breakout Box Cable
MMC Axis A"n" to Breakout Box Cable
a. The Breakout Box for the Axis Connector can be attached to the A1, A2, A3, and
A4 ports on the Standalone MMC Control or the MMC Axis I/O Option Module.
The pinouts on the terminal strip interface provide a one-to-one transfer of the
signals from the connector to the respective pin(s) on the terminal block. The
ground pin on the terminal strip provides a connection to the metal D-shell.
Figure 4-8: Axis I/O Port Breakout Box Dimensions
4.6.1.1

Axis I/O Port DC Outputs

Each Axis I/O Port provides 2 sink or source 24 Vdc outputs. Each of the 2 outputs on
is a solid state switch rated at 100 ma. When the DCOSS pin is tied to the +24V, the
outputs will be in a source configuration as shown in
is tied to COMMON, the outputs will be in a sink configuration as shown in
10.
For safety reasons, all outputs turn off (no current flow) when a scan loss condition
occurs.
For more information on DC output operation, refer to
Appendix
Standalone MMC Hardware Manual
version 15.1
Table 4-27: Axis I/O Port Breakout Box and Cables
1.750"
2.250"
A.
Standalone MMC Control
Length Part Number
N/A M.1016.2529
.3 M (1 ft) M.1016.2535
.6 M (2 ft) M.1016.2536
.9 M (3 ft) M.1016.2537
3.000"
1
9
2.250"
Figure 4-9. When the DCOSS pin
Section A.3 on page 174 of
a
8
15
Figure 4-
67