Table of Contents
Advertisement
Danaher Motion
8
MMC Profibus Option Module
8.1
Introduction
The MMC Profibus scanner module is an interface between the MMC and a Profibus
network. The module contains an on-board processor, a Profibus compliant interface,
and firmware that makes it act as the master to all other nodes on the network.
Prior to initial operation, a file is generated with specific configuration software in an
external PC. This file must be downloaded via the RS232 configuration port to the
Profibus module prior to initial operation. Two indicator LEDs (IN/OUT) are connected
to this configuration port.
Directly above the Profibus port are two LEDs that provide operation information:
Network Status and Profibus Scanner Status.
The DIAG LED goes on briefly while the diagnostic tests are running.
Standalone MMC Hardware Manual
version 15.1
Figure 8-1: MMC Profibus Module
NETWORK
STATUS
CNFG
PORT
MMC Profibus Option Module
Profibus
Diagnostic LED
DIAG
CNFG PORT
Configuration Port LEDs
IN
OUT
SCANNER
Network/Scanner LEDs
STATUS
Profibus Port
Profibus
PORT
Configuration Port
137
Advertisement
Table of Contents
