System Status Lights; Power Status; Battery Status - Danaher Motion Standalone MMC Hardware Manual

Table of Contents

Danaher Motion

In order to:

Turn off the entire application.

Wire the I/O to the application.

Change the battery.

Connect/disconnect the MMC with the com-

puter workstation through the PiCPro port.

Connect/disconnect the MMC with an opera-

tor interface through the User port.

Download an application program into the

memory.

Stop the scan.

3.8

System Status Lights

Three lights on the front of the Control (Scan, Power, and Diagnostic labeled "S", "P",

and "D"), shown in

including power supply status, battery status, diagnostic status, and system status.

3.8.1

The green Power light (P) indicates that the power supplies internal to the MMC are

working properly. If the power light (P) does not go on, or goes off during operation of

the system, check that the proper voltage is present at the MMC power connector. If it

is, turn off the main disconnect switch and replace the MMC.

3.8.2

Battery Status is reported for the Standalone MMC Control and the Standalone Digital

MMC Control as follows:

Standalone MMC Hardware Manual

version 15.1

Table 3-2: Maintenance Procedure Summary

Figure

3-8, provide diagnostic and operational information

Figure 3-8: Status Lights

Installation, Operation, & Maintenance

Turn off main disconnect (which should also