Table of Contents
Advertisement
Danaher Motion
7
MMC DeviceNet
7.1
Introduction
The MMC DeviceNet
DeviceNet network. The module contains an on-board processor, a DeviceNet
compliant interface, and firmware that makes it act as the master to all other nodes on
the network.
Prior to initial operation, a file is generated with specific configuration software in an
external PC. This file must be downloaded via the RS232 configuration port to the
DeviceNet module prior to initial operation. Two indicator LEDs (IN/OUT) are
connected to this configuration port.
Directly above the DeviceNet port are two LEDs that provide operation information:
Network Status and DeviceNet Scanner Status.
The DIAG LED goes on briefly while the diagnostic tests are running.
Standalone MMC Hardware Manual
version 15.1
TM
Option Module
scanner module is an interface between the MMC and a
™
Figure 7-1: MMC DeviceNet Module
DeviceNet
TM
DIAG
CNFG PORT
IN
OUT
NETWORK
SCANNER
STATUS
STATUS
DeviceNet
tm
PORT
CNFG
PORT
MMC DeviceNet
Diagnostic LED
Configuration Port LEDs
Network/Scanner LEDs
DeviceNet Port
Configuration Port
TM
Option Module
131
Advertisement
Table of Contents
