Danaher Motion Standalone MMC Hardware Manual page 101

Danaher Motion
Use this table to wire from the Block I/O Port to the first Block I/O
9-Pin male D-sub (to Block I/O
Pin
3
4
5
6
7
Shell
Description
MMC Block I/O Breakout Box
MMC Block I/O Connector to Breakout
Box Cable
MMC Block I/O Connector to Breakout
Box Cable
MMC Block I/O Connector to Breakout
Box Cable
a. The Breakout Box for the Block I/O connector can be attached to the "BLK I/O"
port on the MMC Control. The pinouts on the terminal strip interface provide a
one-to-one transfer of the signals from the connector to the respective pin(s) on
the terminal block. The connector pins marked with the "ground" symbol on the
screw connector are connected to the "D" connector shell for shield grounding
purposes.
Standalone MMC Hardware Manual
version 15.1
Table 5-5: Block I/O Port to Block I/O Module Wiring
Port, face view)
1
6
9
5
Signal
Transmit Data +
Transmit Data -
Receive Data +
Received Data -
Shield Ground
Drain
Table 5-6: Block I/O Port Breakout Box and Cables
Standalone Digital MMC Control
Module.
5-Pin Pluggable Screw Terminal
(to Block I/O Module, face view)
1
2
3
4
5
Pin Signal
1 Receive Data +
2 Received Data -
4 Transmit Data +
5 Transmit Data -
3 Shield Ground
Shell Drain
Length
N/A
.3 M (1 ft)
.6 M (2 ft)
.9 M (3 ft)
Notes
Twisted Pair
Twisted Pair
a
Part Number
M.1016.2533
M.1016.2543
M.1016.2544
M.1016.2545
101