Connecting The Server To Power - Nortel HMS400 Installation And Configuration Manual

To connect the mouse, keyboard, and monitor to the server
1. Place the monitor, keyboard, and mouse in the same location as the server.
2. Plug the keyboard and mouse into the appropriate PS/2 connectors on the chassis rear panel.
3. Plug in the monitor connector. Tighten the screws on the connector.
4. Connect the power cord to the monitor, and plug the other end into a wall receptacle or power
bar.
5. Turn on the monitor.
To connect the modem to the server
1. Connect the 'B' end of the USB A-B cable to the back of the modem.
2. Connect the 'A' end of the USB A-B cable to a free USB port at the rear of the server.
3. Connect one end of the telephone cable to the modem RJ-11 jack labeled LINE.
4. Connect the other end of the telephone cable to the RJ-11 jack in the wall.
5. Modem is already turned on and ready to be used.

Connecting the server to power

Before you begin
Nortel Hospitality Messaging Server 400
Installation and Configuration Guide
April 2006
-55-