Test Set Address; Rf Switch Driver Commands - Agilent Technologies 8511B Operating And Service Manual

Test Set Address

RF Switch Driver
Commands
Operation
Operation
The address of the active test set can be changed manually from the analyzer
front panel by selecting the
address of the test set and pressing
control using the analyzer's GPIB
a particular test set is set by the address switches on the test sets rear panel
(see Figure 6-4 on page 6-6).
A related feature of the analyzer is that when the 8510
function is changed, a code sequence is automatically issued over the 8510
system bus to the device at the
configuration, this device is an Agilent 11713A attenuator/switch driver
which in turn controls one or more coaxial switches. As shown in
on page 4-7 and Figure 4-6 on page
which of the test sets receives the RF output of the network analyzer source.
The exact command issued depends upon the new value of the
function, also shown in
TEST SET]
page 4-11.
4-10 Agilent 8511B Test Set Operating and Service Manual
function, then entering the
[ADDRESS of TEST SET]
, or it can be changed under program
[x1]
command. The GPIB address of
ADDRESS
. In the recommended
[ADDRESS of RF SWITCH]
4-11, these switches are used to select
Figure 4-5 on page 4-7
[ADDRESS of TEST SET]
Figure 4-5
[ADDRESS of
and Figure 4-6 on