Replacement Procedures; Introduction; Equipment Needed But Not Supplied - Agilent Technologies 8511B Operating And Service Manual

7

Introduction

Equipment Needed
But Not Supplied
Table 7-1
Tools
2 point pozidriv screwdriver
1 point pozidriv screwdriver
5/16-inch torque wrench, 90 N-cm (8 in-lb)
2.4 mm gauge kit
Anti-static mat
Wrist strap
Clip lead
Wire cutters
T-10 TORX screwdriver
T-15 Torts screwdriver
9/16-inch nut driver
1/2-inch torque wrench, 280 N-cm (25 in-lb)
100 ohm 20 watt resistor
5/16 open-end wrench
1/2-inch open-end wrench

Replacement Procedures

This chapter consists of the following replacement procedures:
(1) Frequency converter
(2) Regulator board assembly
(3) Filter capacitors
(4) 2.4 mm RF connectors
(5) B1 fan
(6) T1 power transformer
Table 7-1 lists all the equipment needed to replace the assemblies
documented in the following procedures. Use
locate the assemblies in the Agilent 8511B test set.
Equipment Needed to Replace Test Set Major Assemblies
Figure 7-1 on page 7-2
Used For
all components
all components
all components
port connectors
all components
all components
C1 - C4 capacitors
B1 fan
all components
all components
connector repair
connector repair
C1 - C4 capacitor removal
fan replacement
RF input connector
Agilent 8511B Test Set Operating and Service Manual 7-1
Replacement Procedures
to
Agilent Part Number
8710-0900
8710-0899
8710-1765
85056A calibration kit
9300-0797
9300-0910
any supplier
any supplier
8710-1623
8710-1622
8720-0008
8710-1581
0819-0019
any supplier
any supplier