Agilent Technologies 8511B Operating And Service Manual page 33

Table 2-2
Parameter
2
Dynamic Range
all inputs
3
Accuracy Enhanced Crosstalk
–115 dB
Typical Drift (typical)
Phase (0.01 + 0.01 f (GHz) X V °C, degrees
Input Ports
Connector type: precision 2.4 mm female
Impedance: 50 ohms nominal
Damage level: +13 dBm (20 mW) CWRF input
Port input power for phase lock:
1. The performance parameters listed are characteristic of the 8511B. They are typical or nominal figures and are not field verifiable.
2. Determined by 0.1 dB compression level and system low level peak noise. Low level peak noise measured with 50 ohm load at port and 1024
averaging factor. Noise floor varies with averaging factor. (10 log averaging factor.) Low level noise is calculated from low level noise +10.4 dB.
3. Effective crosstalk with isolation, calibration, excludes noise.
4. Do not exceed –5 dBm input to the sampler for the proper phase lock operation.
Specifications
8510/8511B Characteristics
0.045 to 8 GHz 8 to 20 GHz
110 dB 112 dB
(–10 to –120 dBm) (–10 to –122 dBm)
–115 dB –113 dB
Magnitude 0.001 X V °C, linear
4
Frequency
0.045 to 8 GHz
8 to 20 GHz
20 to 26.5 GHz
40 to 50 GHz
2-2 Agilent 8511B Test Set Operating and Service Manual
1
20 to 40 GHz
107 dB
(–15 to –122 dBm)
–110 dB
Minimum Maximum
–41 dBm –5 dBm
–39 dBm –5 dBm
–32 dBm –5 dBm
–30 dBm –5 dBm
40 to 50 GHz
102 dB
(–20 to –122 dBm)
–105 dB