Operation; Introduction; Front Panel Features - Agilent Technologies 8511B Operating And Service Manual

4

Introduction

Front Panel Features

Figure 4-1

Operation

This chapter illustrates the features and functions of the front and rear panels
of the Agilent 8511B (see
chapter also describes the multiple test set option (Option 001). It explains
the setup and use of one or more test sets in a system.
Front Panel Features of the Test Set
1. Line Switch. This switch turns the test set on and off. When the side of
the switch labeled 0 is depressed, the test set is off; 1 is on.
2. Line LED. This LED goes on and off with the test set line switch.
3. Active LED. This LED lights about two seconds after power is turned
on following a successful conclusion of self-test. If the test set is used
with other test sets (Option 001) and is not addressed by the 8510, this
light remains off.
4. Input Ports b , a , a
1 1
the samplers within the instrument. Port a
phaselock. These ports are precision 2.4 mm connectors and all
connections must be torqued to no more than 90 N-cm (8 in-lb).
Figure 4-1 and Figure 4-2 on page
, and b . These input ports transmit RF energy to
2 2
or a
1
Agilent 8511B Test Set Operating and Service Manual 4-1
4-2. This
must be used for system
2