A2 And B2 Test - Agilent Technologies 8511B Operating And Service Manual

Figure 4-4

a2 and b2 Test

4. Press PARAMETER,
trace.
Typical Operator's Check CRT Trace
5. Press to observe the b1 power level trace.
[User 4 b1]
1. Reconnect the semi-rigid cables (as in step 3 of "a1 and b1 Test") to
ports a2 and b2. Disregard the running error message
FOUND".
2. Press
[User 3 a2], [REDEFINE PARAMETER], [PHASE LOCK], [a2], [REDEFINE DONE]
observe the a2 power level trace.
3. Press
[User 2 b2], [REDEFINE PARAMETER], [PHASE LOCK], [a2], [REDEFINE DONE]
see the b2 trace.
4. If any of the traces are not within the limits noted above, check all of the
connections and repeat the above procedure. If symptoms persist, refer
to the "Service and Equipment Overview" chapter in the Agilent 8510C
On-Site Service Manual.
to observe the a1 power level
[MENU], [User 1 a1]
Agilent 8511B Test Set Operating and Service Manual 4-5
Operation
Operator's Check
"Caution: NO IF
to
to