Checking The Ethernet Interface Status Of The Cs 1000 (Ld 137); Enabling The Ethernet Interface On The Cs 1000 (Ld 137) - Nortel CallPilot Supplementary Manual

Table 5
LD 117 - Define default Gateway
Command
new route x.x.x.x a.b.c.d

Checking the Ethernet Interface status of the CS 1000 (LD 137)

Perform the following procedure to check the Ethernet interface status.
Checking the Ethernet interface status of the CS 1000 (LD 137)
Step
1
2
3
4
Table 6
LD 137 - Check Ethernet interface status
Command
STAT ELNK

Enabling the Ethernet interface on the CS 1000 (LD 137)

Perform the following procedure to enable the Ethernet interface.
Enabling the Ethernet interface on the CS 1000 (LD 137)
Step
1
2
3
Solution Integration Guide for Communication Server 1000/CallPilot/Contact Center/Telephony Manager
Copyright © 2006, Nortel Networks
.
Description
Configures a new routing entry, where
x.x.x.x = network IP address. For a default Gateway, enter 0.0.0.0
a.b.c.d = Gateway IP address of the local CS 1000 system
Action
Connect to the Call Server.
Enter LD 137.
Enter the commands described in the following table.
Check that the parameter ELNK is ENABLED.
If ELNK is not ENABLED, perform the procedure
Ethernet interface on the CS 1000 (LD 137)" (page
Description
Displays the status of the Ethernet link on the active IOP card
Action
Connect to the Call Server.
Enter LD 137.
Enter the commands described in the following table.
Enterprise: Common
NN49000-300 01.01 Standard
CS 1000 Release 4.5 20 December 2006
Checking the system status 23
—End—
"Enabling the
23).
Nortel Networks Confidential