Configuring The Elan Subnet (Ld 17) - Nortel CallPilot Supplementary Manual

26 CS 1000 configuration
Configuring the ELAN subnet (LD 17)
Define and configure the ELAN subnet for the AML link and its associated
VSID in the configuration record. This provides the Ethernet connection
over which AML messages are exchanged between the CS 1000 system
and CallPilot. A separate ELAN must be created for CallPilot and Contact
Center for the purpose of integration.
Perform this procedure only if the ELAN subnet is not provisioned.
Configuring the ELAN subnet (LD 17)
Step
1
2
3
4
Table 10
LD 17 - ELAN subnet
Prompt Response
REQ CHG
TYPE CFN
ADAN NEW ELAN xx
- CTYP ELAN
- DES x...x
VAS NEW
Solution Integration Guide for Communication Server 1000/CallPilot/Contact Center/Telephony Manager
Copyright © 2006, Nortel Networks
.
Action
Connect to the Call Server.
Enter LD 17.
Enter the appropriate values as described in the following table.
For prompts not listed in the following table, press Enter to accept
the default.
To exit the overlay, enter **** and press Return.
Enterprise: Common
NN49000-300 01.01 Standard
CS 1000 Release 4.5 20 December 2006
—End—
Descriptions
Change existing data block
Configuration record
Configure a new link and assign it a
number, where xx is within the ELAN
subnet range (16–31). You can use any
number in this range as long as it is not
already used. Make a note of this link
number for your reference.
Card type
Enter a designator of up to six characters
in length to identify this ELAN subnet.
Because the ELAN subnet is not
dedicated to a specific application,
make the designator generic.
Configure a new AML link or change the
existing link configuration.
Nortel Networks Confidential