Cs 1000 Configuration Checklist - Nortel CallPilot Server User Manual

CS 1000 configuration checklist
Introduction
The following checklist provides a list of the tasks you must complete for
correct CallPilot and CS 1000 system interoperation. Detailed instructions
are provided for each task, as indicated, in the remainder of this chapter.
Configuration checklist
Step
1 Ensure that the ELAN subnet
for the AML link and its
associated VSID in the
configuration record is defined.
This provides the Ethernet
connection over which AML
messages are exchanged
between the CS 1000 system
and CallPilot.
2
Define the Message Register
for AML message tracing.
3 If the CS 1000 system has
not been defined with an IP
address, configure it for the
ELAN subnet interface.
4
Enable the ELAN subnet link.
5 Enable the ELAN subnet
connection.
Note: You can also print configuration information from overlay 20 at any time.
Copyright © 2007, Nortel Networks
.
Nortel CallPilot
Communication Server 1000 and CallPilot Server Configuration
NN44200-312 01.02 Standard
5.0 3 May 2007
CS 1000 configuration checklist 53
Overlay See page
17 "Provisioning the ELAN
subnet" (page 57)
17
"Defining the Message
Register for AML
message tracing" (page
59)
"Configuring CS 1000 IP
addresses and enabling
the Ethernet interface"
(page 59)
137
"Configuring CS 1000 IP
addresses and enabling
the Ethernet interface"
(page 59)
48 "Configuring CS 1000 IP
addresses and enabling
the Ethernet interface"
(page 59)
Check