Replacing An Mgate Card (Ntrb18Ca) - Nortel CallPilot Server User Manual

What is next?
Continue with
(page

Replacing an MGate card (NTRB18CA)

Introduction
If the MGate card becomes faulty, follow this procedure to replace it.
To replace an MGate card
Step
1
2
3
4
5
6
Copyright © 2007, Nortel Networks
.
"Section B: Connecting the CallPilot server to the switch"
40).
Note: You do not need to power down the switch for this procedure as
the MGate card is hot-swappable.
Action
Courtesy stop the DS0 channels from the CallPilot administrative PC
to stop all call processing gracefully.
To do this, use the Channel Monitor or the Maintenance page in
CallPilot Manager, as described in the CallPilot Server Maintenance
and Diagnostics guide for your server.
Note: If your system has multiple MGate cards, you can choose
to courtesy stop only the DS30X channels that belong to the
MGate card that is being replaced.
Remove the switch's front cover to expose the shelf slots.
Open the latches to unlock the faulty MGate card.
Remove the faulty MGate card from the switch.
Press the replacement MGate into the same slot that the faulty
MGate card occupied.
Note: Note: If you place the MGate card in a new slot, then
you must do the following:
a. Reprogram the switch to account for the new slot number.
b. Move the DS30X cable to the new slot.
c. Reconfigure the software from the CallPilot administrative client
PC.
Press the latches on the top and bottom of the MGate card to close
them.
Result: Result: This locks the card into position against the
backplane.
Nortel CallPilot
Communication Server 1000 and CallPilot Server Configuration
NN44200-312 01.02 Standard
5.0 3 May 2007
Replacing an MGate card (NTRB18CA) 39