Nortel CallPilot Server User Manual page 43

Cabling diagrams
The following table lists the supported configurations and the page number
that illustrates the configuration.
Cabling configurations
Number of
channels
32 or less
32 or less
48 or less
48 or less
Identifying the location of MPB 1 and MPB 2
In the cabling diagrams, the terms MPB16-4 #1 and MPB16-4 #2 are used
to identify the two MPB16-4 boards. The table below indicates the location
of these boards.
MPB16-4 slot locations
MPB Number
MPB16-4 #1
MPB16-4 #2
Identifying the location of MGate 1, 2, and 3
In the cabling diagrams, the terms MGate #1, MGate #2, and MGate #3
identify the MGate cards. MGate #1 is in the lowest-numbered slot in the
Media Gateway or Media Gateway Expansion. MGate #2 and MGate #3
are in the next available higher slots.
One MPB16-4 board and one MGate card (32 channels or less)
Use the single cable (NTRH2012) to connect the MPB16-4 board to the
MGate card. See
Copyright © 2007, Nortel Networks
.
Connecting MPB16-4 boards to MGate cards (NTRB18CA) 43
Number of
MPB16-4
boards
1
2
1
2
Note: On the 1002rp servers, MPB16-4 #1 is the MPB16-4 board
closest to the SBC card. For more information on slot assignments, see
the slot assignment tables in the CallPilot Server Hardware Installation
guide for your server.
"MGate cabling for the 1002rp server" (page
Nortel CallPilot
Communication Server 1000 and CallPilot Server Configuration
NN44200-312 01.02 Standard
5.0 3 May 2007
Number of
MGate cards See
1
1
2
2
1002rp server
slot 11
slot 12
44).