Nortel CallPilot Server User Manual page 60

60 Chapter 4 Configuring the CS 1000 system
Notes:
•
•
To change an IP address after CallPilot is installed and running, you must do
the following:
1 Courtesy stop and shut down CallPilot.
2 Change the IP addresses on the switch, as described in this section.
3 Restart CallPilot.
4 Rerun the CallPilot Configuration Wizard to update the switch IP address
information.
To configure the IP addresses and enable the Ethernet interface
The following data is used in examples in this procedure:
Data
Primary IP address
Primary Host Name
Subnet mask
Default gateway IP address
Network IP address
Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
The CS 1000 system has dual CPUs.
If the CS 1000 system is also connected to a Nortel Server Subnet (NS
Subnet), you must define a gateway IP address.
Action
Load overlay 117.
Perform the following substeps to check the current IP addresses to
see if they already match what you plan to configure for CallPilot.
If the current values displayed by the following commands must be
updated, then continue with the remaining steps in this procedure.
Otherwise, go to step 15.
a. Type PRT HOST and press Enter.
b. Type STAT HOST and press Enter.
c. Type PRT MASK and press Enter.
d. Type PRT ELNK and press Enter.
Load overlay 137.
Type DIS ELNK and press Enter.
Nortel CallPilot
Communication Server 1000 and CallPilot Server Configuration
NN44200-312 01.02 Standard
5.0 3 May 2007
ATTENTION
Value (examples only)
47.1.1.10
PRIMARY_HOST
255.255.255.0
47.1.1.1
0.0.0.0