Installing the server and peripheral devices
Connecting the server to the Nortel Server
Subnet (optional)
Introduction
This section provides instructions to connect the server to the Nortel
Server Subnet.
Note: The Nortel Server Subnet is optional. However, it is required to
support desktop and web messaging users.
ATTENTION
To connect the server to the Nortel Server
Subnet
1
See the diagram on page
2
Connect an RJ-45 network cable from the Nortel Server Subnet hub
to the CLAN connector.
What is next?
Continue with
55.
54
To comply with EMC radiation requirements, a Class A
hub must be located 10 m (33 ft.) away from the 1005r
server. Shielded Ethernet cables must be used.
"Installing the Nortel software feature dongle" on page
47
to locate the CLAN connection.
Standard 1.06
CallPilot