To Display The Nortel Callpilot Image Menu; 600R Server Maintenance And Diagnostics; Nn44200-703 01.04 Standard - Nortel CallPilot User Manual

98 Chapter 9 Maintaining the BIOS and system board firmware
When to upgrade the BIOS
The CallPilot server is shipped with the required minimum BIOS version.
Upgrade the BIOS only if your Nortel representative deems this necessary
to solve a system problem.
When to reconfigure the BIOS
The initial BIOS configuration is performed at the factory before the CallPilot
server is shipped to you. Reconfigure the BIOS only after you recover from
a BIOS or CMOS failure.
Requirements for upgrading or reconfiguring the BIOS
You must have the CallPilot Image DVD to upgrade or reconfigure the BIOS.
You must have all the hardware components of your system installed and
connected before you upgrade the BIOS.

To display the Nortel CallPilot Image Menu

Step
1
2
3
4
Copyright © 2007, Nortel Networks
.
CAUTION
Risk ofdata loss
Perform this procedure only if specifically instructed to do so by
your Nortel representative.
Action
Insert the CallPilot Image DVD for the platform into the DVD drive.
Power down the CallPilot server.
Restart the CallPilot server.
Result: The server boots from the DVD and the Startup Menu
appears with the following options:
1.Install CallPilot 5.0 600r server image and exit
to DOS (recommended).
2. Install CallPilot 5.0 600r server image and
exit to DOS (FACTORY ONLY).
3.Utilities (BIOS, Firmware, etc...)
Select 3, Utilities (Bios, Firmware, etc...), and press Enter.
Result: The Nortel CallPilot Image Menu appears.
1. 600r server BIOS update
2. 600r FRU/SDR firmware update
3. 600r server Display Non-Default CMOS Settings
4. 600r server SSU
Nortel CallPilot

600r Server Maintenance and Diagnostics

NN44200-703 01.04 Standard

5.0 25 April 2007
ATTENTION